Had to switch controllers and install new endstops but can't figure out how to wire them. Posting pics of the controller and end stops, maybe someone has used
these and can tell me what I'm doing wrong, thanx
Thread: End Stop Problem?
Results 1 to 4 of 4
-
12-26-2018, 06:32 PM #1
Member
- Join Date
- Dec 2017
- Posts
- 47
End Stop Problem?
-
12-26-2018, 06:49 PM #2
Member
- Join Date
- Nov 2012
- Posts
- 1267
Re: End Stop Problem?
You have 6 pairs of pins for 6 "end stops" (more commonly called "limit switches"). Just connect each switch to its own pair of pins. Use the normally closed contacts on the switch, leave the third contact disconnected.
-
12-26-2018, 06:56 PM #3
Member
- Join Date
- Dec 2017
- Posts
- 47
Re: End Stop Problem?
Thanx, I'll try it
-
12-27-2018, 06:09 PM #4
Member
- Join Date
- Dec 2017
- Posts
- 47
Re: End Stop Problem?
Tried this, no luck, have never had a problem with this before, e-stop, hold and resume all working fine, just can't figure this one out. Brand new controller, but may be defective?
Reply With QuoteSimilar Threads
-
E-Stop Problem
By kewl_cat in forum CNC Machine Related ElectronicsReplies: 1Last Post: 09-19-2012, 12:46 AM -
E Stop Problem
By Kool Parts in forum Haas MillsReplies: 2Last Post: 09-02-2011, 08:04 PM -
Limit/E-stop Problem?
By bigz1 in forum Mach Software (ArtSoft software)Replies: 3Last Post: 03-15-2007, 02:17 AM -
em stop problem
By nicholisc in forum MilltronicsReplies: 5Last Post: 05-09-2006, 03:35 PM -
E-Stop Problem??
By ZR Machine in forum Haas MillsReplies: 14Last Post: 01-31-2006, 05:54 AM
Tags for this Thread
Posting Permissions
