Hi all, I wonder if any of you can tell me if it is possible to convert a Fagor 8055i EDUC/K into a machine controller. There is one of these units for sale on Ebay and I found out that this unit is used for educational purposes and as it stands will not control anything. I suspect the main board is exactly the same. I asked Fagor Automation if it could be done and the reply was that the "sofware key" disabled the axis control, not sure what a "software key" is but it would clearly need different software. I have seen references to upgrading the software on YouTube but there was no indication as to where you got it from, so my questions are do any of you have any knowledge of these units and does anyone know how I can get hold of the software. Fagor's website does not have it. Thanks in advance. Dave