I am setting up an installed a Command CNC Linux system in my existing Mach 3 DHT II system. I run plsma only. Sheetcam is downloaded onto the CandCNC computer I purchased and is set up for Linux. Most sheetcam tools the same as I have used in my older Sheetcam Mach 3 system but when I went to run a simple oval cut through this new Linux Sheetcam process I got post Processor failed. "Define a diameter". Iam not drilling or running a router. How do I get rid of this post processor diameter issue?
Results 1 to 2 of 2
-
02-26-2016, 02:33 PM #1
Registered
- Join Date
- Apr 2012
- Posts
- 1
Sheetcam Plsma. Post prosser requires Diameter.
-
04-11-2016, 06:30 PM #2
Registered
- Join Date
- Sep 2008
- Posts
- 18
Re: Sheetcam Plsma. Post prosser requires Diameter.
You should enter the kerf width as the diameter. In other words, the plasma flame itself has a diameter, and you can figure out it's size by measuring the width of a straight cut.
Reply With QuoteSimilar Threads
-
Can anyone help with sheetcam post processor?
By twooten in forum SheetCamReplies: 4Last Post: 03-30-2015, 06:48 PM -
Can anyone help with sheetcam post processor?
By twooten in forum Waterjet General TopicsReplies: 1Last Post: 01-25-2008, 09:02 PM -
sheetcam 5.0.1 post processor for dynacnc
By lowelife in forum Post Processor FilesReplies: 2Last Post: 10-07-2007, 09:14 PM -
Hurco BMC20 Post Prosser help
By moorport in forum CNC (Mill / Lathe) Control Software (NC)Replies: 12Last Post: 02-06-2007, 05:19 PM
Tags for this Thread
Posting Permissions
