Hello,
I have some doubts, I recently finalize to build my own CNC plasma table, I'm using a COR 60 CNC plasma cutter, and for the controller SF-2100C with THC system, but I have a problem with the trigger, this is always activated, Have you faced this kind of problem?
On the manual for the Plasma cutter indicated the following:
pin 9 and 8 - trigger signal
pin 7 and 6 - arc signal
pin 14 and 13 - arc pilot
If I'm using the SF-HC25G for THC controller and SF-HC30A for splitter, Could I connect directly the CNC port to splitter or the THC controller? or do you have another solution in order to brake the arc?
http://youtu.be/Ukf4uCbZHIQ