Its been way to short a time for me to be back for help but I sure hope I can find some anyhow...
I have an arrow 1000 with 2100 control. This morning I started it up and hear a loud fan. Open the cabinet and its the spindle drive fan . I cleaned it up and it seemed fine, now its not working at all. Will this cause any problems elseware? I have no overtemp alarm but, I just started to get this overcurrent fault light on my x drive bds4 (and alarm 39-53) after about twenty minutes of running fine. Turn it off and refire and its fine for another 20 min. ??? I am going to pull the spindle drive and see if I can find a fan for it, but I am in deep here, I dont know where else to start.
Thanks for the help