Hi everyone - new here - first post!
We're a small sheet metal shop in sunny CapeTown and have just installed a 1996 AMADA PEGA 357 with Fanuc 6M control - all good so far......but embarrassingly have a cable with 3 wires in it labelled 21, 22, & 23 and not sure where to connect it in control panel could have sworn I took photo's of all connections when I decommissioned from previous owner but.....errrr......apparently not.
Would really appreciate some guidance here - perhaps someone has the same machine/controller and could send a photo? - Talk about "so near, but so far"