Say I have a stock of 500x500x20mm sheet metal. I need to mill to get a 100mm dia round piece (and have the rest of the sheet). What operation would the best for the job?
Say I have a stock of 500x500x20mm sheet metal. I need to mill to get a 100mm dia round piece (and have the rest of the sheet). What operation would the best for the job?
I am new to this using fusion360 I did similar with 3mm aluminium in mini mill setting up a 200mm circle and using 2d contour cut from stock extended over all sides.
Mill it on aluminum plate. Just mill a down helix spiral at slow feed rate.
Sent from my Nexus 5 using Tapatalk