Originally Posted by
SGi99
Hello Cahit,
thank you for your very useful plugin and the work you put into that.
Question:
I have my tool length sensor set to be activated when the contact is interrupted (the usual safe way). The way PCB probing usually works is that the probe detects a short between PCB and drill bit, so it is just the opposite.
Is there a way to configure the Autoleveler if active high or active low is used - for just the autoleveler plugin - without setting up a new UCCNC profile or entering the setup dialogue ? When writing Macros, it is possible to ask for the LED state, but since the plugin is a dll there is no access to the config of the probing logic.
It would be nice to use a single UCCNC profile to use the standard toool length sensor for drilling the PCB, then change to engraver, do the autoleveling and then start engraving isolation paths.
Or is there something I missed how to set up that behaviour easily ?
Thank you !
Sven