Ok... So landed in my workshop two days ago is another machine.
This was meant to be an easy one, was running with the previous owner with no issues (according to the broker)
The lathe powers up fine, hydraulic pressure is correct & the slideway lube pumps so the phase is ok coming to the machine. (The slideway lube doesn’t stop pumping however, which makes me wonder if the parameters have been lost, the battery light is on)
This is the startup procedure I am using:-
Main power breaker on rear of machine on.
Black on button on T5 Control panel on
Press black Hyd/Lube Button
At this point the machine ready light comes on.
The turret indexes & there is hydraulic movement with the tailstock center & chuck.
However, I cannot get the X & Z axis to move at all, either jogging or with the handle. (I am not even 100% convinced the servos are firing up at all)
The machine lock is in the off position.
If I hold down the rapid button & use the Jog joystick, I can get an alarm (1 under SV on the CP) but nothing else.
Any ideas?
Thanks
N