What Post Processor do I select for use in VCarve Pro for the KRMx01?
Thanks
What Post Processor do I select for use in VCarve Pro for the KRMx01?
Thanks
What control software are you using?
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Mach III
Then you'd use one of the Mach3 post processors.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks! I'll give her a shot.
https://www.dropbox.com/s/8akchudzyb...58.55.png?dl=0
There are a bunch of them. Not sure which to choose. Mach III ARCs Inch? How do I go about determining the correct one? I can upload the project if need be so you can see what I am doing...
If your using inches, and only one tool, then use the arcs-inch.
if you want to use multiple tools in one g-code file with tool changes, use the arcs-inch ATC post.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Yes, that is the one.
Author of: The KRMx01 CNC Books, The KRMx02 CNC Books, The KRmc01 CNC Milling Machine Books, and Building the HANS Electric Gear Clock. All available at www.kronosrobotics.com