I hope this is in the correct forum..

I'm new to the CNC world, but have managed to cut a couple of wood items. Then, I went to curve on a thin board, and I allowed the spindle to go to deep into the waste board, heard a pop in the electronics' cabinet.

Now when I power up the unit, I hear the spindle whine, turn about 1/2 turn then stop.
I have an error E013 on the Fuling dzb200b unit.

I have no idea if that error is causing the problem, and if so, how to reset it, even after reading the Fuling manual, since I control everything with a PC and Mach3.

The spindle is free to turn by hand. And all motion controls are working okay.

Any suggestions will be appreciated.