Hi all-
I finally have the rs-232 working, and now the mill has died!
The mill was working fine, left it powered up, and started working on a lathe project. I heard the lathe drop power. It did not have any faults on the screen, but it was locked up, and would not power back up. Powered down and back up . Nothing. Tried again. Still nothing.
Checked the fuses, checked the transformers. All appear good.
When I power the mill on, usually the diagnostic screen runs on the left monitor. Then it will power on.
Now it runs on the right monitor. It says everything is OK.
The left screen just has a flashing curser. That is all.
Any ideas where to start?
Steve
Steve
Sent from my iPhone using Tapatalk