[lanemfg]

I picked up a new to me a centurion VI mill through an auction. The monitor had died before I got it. It powered up before I went to move it, but that was all I had checked. Anyway I got it home and in the shop, hooked all the stuff back up and replaced the monitor. I powered it up and it did not boot quite right, I found how to fix that and booted to the correct screen, but when I went to put some of the stuff back together I knocked the video card out while it was powered up and it had quit working on me. I tried other video cards and could get nothing. I had some old ISA motherboards around, and tried replacing the motherboard, and in so doing it is not recognizing any of the buttons on the control, or any of the drives.
Can anyone maybe help me figure out what to do now in getting this mill back up and running correctly?

[ZZZZ]

It sounds like you should think about a Single-Board-Computer upgrade.
Send SportyBob a PM, he will give you the details on his SBC deal.

[lanemfg]

Thanks ZZZZ, I will do that.