584,808 active members*
5,053 visitors online*
Register for free
Login
Results 1 to 3 of 3
  1. #1
    Join Date
    Oct 2006
    Posts
    157

    Daewoo Puma 10 is off

    Hello,
    I am trying to set up this Daewoo Puma 10 .
    I have the correct boring bar bushing and boring bar.
    For a test to see it it was centered .... I ran it across the face of the material.
    It leaves a nipple in the material that is 2.8mm or .110"
    The tip of the tool is high.

    How do you adjust this.

    Thanks for the help.

  2. #2
    Join Date
    Feb 2009
    Posts
    6028

    Re: Daewoo Puma 10 is off

    Run an indicator along the slot that holds turning tools, it should run parrallel to the X axis. If not, your problem is mechanical, and you will need to do a turret alignment. Some of those Pumas required removal of the turret disk to get to the taper pins for the coupling.

    Sent from my A3-A20FHD using Tapatalk

  3. #3
    Join Date
    Oct 2006
    Posts
    157

    Re: Daewoo Puma 10 is off

    Hmmm, Sounds good . I will do that tomorrow.
    Thank You!

Similar Threads

  1. Daewoo Puma 10
    By AirChunk in forum Daewoo/Doosan
    Replies: 0
    Last Post: 05-02-2016, 03:18 PM
  2. daewoo puma 8
    By skippyfix in forum Daewoo/Doosan
    Replies: 0
    Last Post: 03-29-2014, 12:44 AM
  3. Daewoo puma 10s
    By bbf468 in forum Daewoo/Doosan
    Replies: 5
    Last Post: 02-17-2012, 01:33 AM
  4. I Need to buy a Daewoo Puma 8
    By gcrudgington in forum Daewoo/Doosan
    Replies: 2
    Last Post: 10-20-2008, 11:24 PM
  5. Daewoo Puma 200
    By williamsxu in forum Daewoo/Doosan
    Replies: 10
    Last Post: 01-17-2007, 11:52 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •