[chrismnj]

Hi guy,not sure if I'm posting this in correct section but need help asap going nuts here. Could anyone tell me whats wrong with my table display? attached are pictures of table display and homing/softlimits

[Kenny Duval]

Yes.. You need to set the work zero and regenerate the tool path after you load the G-code file provided the axis are configured correctly.

[chrismnj]

fell stupid now, thank you

[Kenny Duval]

No need to feel stupid. We all start somewhere. A couple years ago I would not have been able to answer that question.

[chrismnj]

well let me ask you this, is there any way of uploading g code below x axis not above like its doing it now I ma drawing in adobe illustrator and g code is done in meshcam

[Kenny Duval]

You'll have to ask the Meshcam users. I'm pretty sure that would be a post processor issue.