[tfuqua63]

Got my machine inside cleaned up hooked up power and air. Powered it up screen comes on and I had an Alarm 531 -Z axis limit switch so I cleared that up (switch was stuck) and tried it again. I can not get any axis to move in any direction. Well I think I may have found the problem,however I hope that I am wrong. After studying the manuals it appears I may be missing a few boards in the cabinet I have some pics for y'all to look at to confirm this for me
It seems that I need an Axis board an MPG/CRT board and maybe some memory too ?

Attachment 322172Attachment 322180Attachment 322182Attachment 322184

[metalcutting]

hold can+p while power up the machine , Your machine is in Soft limit
than move axis

[tfuqua63]

hold can+p while power up the machine , Your machine is in Soft limit
than move axis

Thanks I have done that it did clear the Alarm code but still no Axis movement ? Thanks

[metalcutting]

After power up you use Handle / MPG towards negative direction to axis movement First
Or do Grid Shift arrangement as :
https://quantumautomation.wordpress....ft-adjustment/

[antfriesen]

2nd LS switch?

[tfuqua63]

Got my machine running :banana:had a local tech come out lucky for me he new my brother inlaw and gave me a really good deal on helping me get it up and running. I was close but would probably never have got it going with out him I also learned a whole lot I can now read the ladders and trouble shoot problems can not say enough the guy was really great !!!!
I have not cut any parts yet maybe next week my son will be home from school and we are going to learn it together will start out with some styrofoam to get started and go from there.:banana::banana::banana: