I went to fire up our lathe after it had set over the weekend, and I have encounterd a slightly major problem. It doesn't want to feed or rapid from G code at all.
Example, If in mdi I command a G0 Z 1.0 the cycle start light just stays on and the turrett never moves.
Or, If I jog the turret to lets say, the middle of travel of both X & Z and then mdi a G28 U 0.0 W 0.0 the machine does not return to reference position
I can jog/handwheel and the turrett moves fine, the machine will zero return as well
I Just printed of the paramaters and I'm going to go double check those to make sure nothing has changed, but dues any body else have any ideas or stuff to try?
Thanks,
Matt
TR Manufacturing