[Aaron92SE]

I do not want to post my drawings here. I will need to make one of these prototypes. Once I confirm the measurements of the final cut prototype, I will place an order to make about 10 more immediately thereafter. And depending on how sales go, I will need to continue to make many more runs in the future.

I am hoping to find a method of cutting that will provide a clean edge, but is very cost efficient.

Can anybody waterjet or laser cut this material without delamination or scorching?

Please email me at adogg18 at yahoo dot com and I will send you the drawings immediately.

Thank you,

Aaron
Eastern NC

[joey1117]

email sent send me a dwg to [email protected] would be happy to quote this for you
joe

[Aaron92SE]

email sent send me a dwg to [email protected] would be happy to quote this for you
joe

You got mail! Thank you.

[slatern44]

Please send over a drawing and I will take a look at it. I machine alot of g10 material and it should be no problem.
Thanks,
Neil Slater

Slater Machine
[email protected]

[Aaron92SE]

Please send over a drawing and I will take a look at it. I machine alot of g10 material and it should be no problem.
Thanks,
Neil Slater

Slater Machine
[email protected]

I'm sorry for not posting this earlier, but I found a company to fulfill my order a few days ago. Thanks for the inquiry.