Good afternoon everyone,
I need help/advice regarding the title of my thread above....
I wrote the program and I'm reasonably confident it is correct, its the execution at the end of the day that is letting me down!
There is 10 teeth on the ID at 36 degree intervals for about 60mm long.(attached is drawing)
The special tool (that I have gotten made by Iscar), goes to the start position in front of material, and stops there on the line where my fees and length of got is ( G1 Z-60 F.2).
My CNC machine is giving no alarms or errors, but is not going any further than the start position mentioned above.
I have a notion the problem might be that the CNC is getting confused as neither the chuck or the live tool is not rotating.
I have looked through the manuals for maybe a code that needs to be in to bypass the problem , but sadly no success.
Any advise or assistance will be greatly appreciated!
Kind regards,
Chris Jonk
+27844421244
[email protected]