Soft E-Stop????
Ok Folks:
Time to reach out for some more cnc knowledge. I'm working on a power drawbar design and when reading over some material noted that on one design, when a drawbar error occurred, the dedicated drawbar software would throw a "soft E-stop" to the break out board. Can someone please explain the difference between a "soft e-stop" and what I am guessing would be a "hard e-stop"? Is this signal available on most popular BOB's? I'm most likely going to get some grief on the second questions since its so general but what the heck!
Many thanks.
Bill
!
billyjack
Helicopter def. = Bunch of spare parts flying in close formation! USAF 1974 ;>)