Hi, i have been asked to try and find out what this error message is. It comes up on Heidenhain TNC151 during startup, but doesnt actually seem to cause a problem with the running of machine (YET). Anyone have any idea?
PROCESSOR CHECK ERROR G
Hi, i have been asked to try and find out what this error message is. It comes up on Heidenhain TNC151 during startup, but doesnt actually seem to cause a problem with the running of machine (YET). Anyone have any idea?
PROCESSOR CHECK ERROR G
The closest alarm to what you are seeing I can find is a TNC ELECTRONICS DEFECTIVE G. (Heidenhain TNC151 service manual, page 12, section 2.2.2).
CLP PROCESSOR RAM is fault cause. CLP PROCESSOR BOARD is the fault location.
Try calling Heidenhain at 1-847-490-1191
George
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks, since posting the thread , i emailed Heidenhain and received a reply saying that it indicates an error with ram, as you say.