[KL1450]

I am in need of a repair source or replacement (used) for Animatics control.
Three or four outputs. (x,y,z minimum)
I have a dead y axis and can not get any output from control. Axis motors function when cables are moved to output ports other than y.

42000 spindle also has issues. Error 12 and spindle will not turn on.

Any assistance with either issue would be much appreciated. I am ok with a separate manual control for spindle on/off and rpm if needed.

-KL

[Fastest1]

Post any pictures you can. They always help.

[Fastest1]

Just putting another title on a thread wont help.

[KL1450]

What might help?
I added a thread: search for controller and fu 2000 drive info. or troubleshoot/replace/repair sources.
-KL

[Fastest1]

Since nobody responded, they are probably not familiar with the machine. But pictures show everything. Many people might identify a piece of electronics and know how to work with it.

[elio123]

I am in need of a repair source or replacement (used) for Animatics control.
Three or four outputs. (x,y,z minimum)
I have a dead y axis and can not get any output from control. Axis motors function when cables are moved to output ports other than y.

42000 spindle also has issues. Error 12 and spindle will not turn on.

Any assistance with either issue would be much appreciated. I am ok with a separate manual control for spindle on/off and rpm if needed.

-KL

i do have a few Animatics controllers and PCB boards, let me know if you still need a controller or PCB board,,, I'm looking for a electrical diagram or pictures for the PCB board connections for a prolight2000 with the newer PCB Board (brown connectors) , I'm upgrading mi machines with 4axis but my machines have the older PCB board.(white connectors)

thanks

[KL1450]

i do have a few Animatics controllers and PCB boards, let me know if you still need a controller or PCB board,,, I'm looking for a electrical diagram or pictures for the PCB board connections for a prolight2000 with the newer PCB Board (brown connectors) , I'm upgrading mi machines with 4axis but my machines have the older PCB board.(white connectors)

thanks

I have Animatics cd5406m v3.5 mfg. 12/95.
Do you have anything that early with the round connections?
I need three axis minimum.

I also need a Lust lumi-drive freq. controller for spindle speed.

-KL

[elio123]

I have Animatics cd5406m v3.5 mfg. 12/95.
Do you have anything that early with the round connections?
I need three axis minimum.

I also need a Lust lumi-drive freq. controller for spindle speed.

-KL

All the animatics that I have are with round connector, please send pictures of your animatics controller, and PCB Board to make sure it fits your system,

I do not have extra lust lumi speed drive, I only have one installed on my Proligh 2500, which I think is what you have.