585,555 active members*
3,067 visitors online*
Register for free
Login

Thread: C AXIS INTERNAL HEX

Results 1 to 2 of 2
  1. 07-02-2016, 04:03 AM #1
    Bala
    Bala is offline Registered
    Join Date
    Dec 2006
    Posts
    29

    C AXIS INTERNAL HEX

    I am cutting a 25 mm id hex and chamfering the hex. every thing is good except chamfer is not following the hex. its cutting one side big other side small.
    Reply With Quote Reply With Quote
  2. 07-05-2016, 01:59 PM #2
    OkumaWiz
    OkumaWiz is offline Registered
    Send a message via AIM to OkumaWiz
    Join Date
    Apr 2009
    Posts
    1262

    Re: C AXIS INTERNAL HEX

    Is the Hex on the centerline or is it off center? Are the coordinates "even" around the hex? Most times uneven chamfer can be due to toolholder alignments, but if you are on center, this will usually not matter. If you are off center and use Y-axis coordinates, then you can have misalignment affect the chamfer size.

    Best regards,
    Experience is what you get just after you needed it.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 1.5 x 11.5 Internal NPT
    By OKUMAN in forum Okuma
    Replies: 4
    Last Post: 05-07-2016, 09:17 AM
  2. Internal Grinding
    By singist42 in forum Uncategorised MetalWorking Machines
    Replies: 7
    Last Post: 01-14-2013, 04:18 PM
  3. internal pocket
    By sterlin in forum CNC Tooling
    Replies: 2
    Last Post: 12-19-2012, 01:01 AM
  4. Internal groove
    By cijunet in forum GibbsCAM
    Replies: 2
    Last Post: 12-12-2007, 11:16 PM
  5. Internal Gears???
    By itsme in forum MetalWork Discussion
    Replies: 11
    Last Post: 02-11-2005, 09:21 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules