I'm going crazy with CypCut. Here is the problem:

We use 2 layers for each type of material. One layer for cutting and the other for markings. I put all the cutting parameters (focus, speed, etc.) for each of these two layers and save it with the name A on the disk. Let's say I set focus -2 and speed 9m/min for the cutting layer. And focus -1 and speed 10m/min for the marking layer and save these parameters in a file named "A".

Then I change these parameters and save it in another file with the name "B".

When I read the file named "A" the parameters are different from those I previously saved. Sometimes "A" gets the parameters from file "B".

This is really crazy and after several attempts I can't figure out the problem. Maybe a software error?

Thank you!