[graupnerhansen]

Hello, I am here again.

Thank you for all of your previous input.

My next question is:

Is it any problem to power my 450WATT servo with my 750WATT servo drive?

The plan is to power this up in my home where I have access to 220V 50hz single-phase electricity.

Will there be any kind of conflict or trouble to take into consideration?

Thank you in advance!

Henrik.

[mactec54]

Hello, I am here again.

Thank you for all of your previous input.

My next question is:

Is it any problem to power my 450WATT servo with my 750WATT servo drive?

The plan is to power this up in my home where I have access to 220V 50hz single-phase electricity.

Will there be any kind of conflict or trouble to take into consideration?

Thank you in advance!

Henrik.

Yes that will work, If the Servo Drive recognizes the Servo motor Encoder, you will also have to make sure the output amps are set to the motor spec's, or you could fry the servo motor, usually though if the Servo Drive recognizes the Servo Motor, it will set the Parameters needed for that motor, this does not always happen so you have to check