[mike4675]

hello. new to the cnc zone forum. im having issues getting the x overtravel message to disappear. after i overtravelled in x-, i rehomed it. can still get everything to home position, but cannot handle or jog x axis anymore. we just bought this used machine and havent even been able indicate tombstone. any advice would be greatly appreciated.

[OkumaWiz]

Normally you can just pulse handle away from the limit and then press the reset to clear the alarm. If this is not working then I think I would check for a sticky overtravel switch that may not be releasing after you move away.

Best regards.

[mike4675]

Normally you can just pulse handle away from the limit and then press the reset to clear the alarm. If this is not working then I think I would check for a sticky overtravel switch that may not be releasing after you move away.

Best regards.

thanks okumawhiz. will give it a try.

[mike4675]

not having that problem today. the machine sat overnight. guess it took that amount of time for something to become unstuck. thanks again for the insight.