[rajesh_1355]

DEAR ALL,

I have a yam make turning m/c with 12 turret post,

Control Fanuc 3T
M/c MAKE : CK-1-3T
M/C MODEL: A02B-00580B501
SR. NO. 71-0784
YAM NO. M-7022
12 TOOL TURRET

In this m/c all function are running except turret indexing in auto cycle.
As turret command is executed, turret index only once , no any alam displayed , dignosis bit 7 of 712 get high & after that no auto operation possible. All the Prox. & micro sw signal are ok.
After control off/on auto operation possible but except turret indexing.
Here under the timers & counter data,


TIMERS VALUE
208 10
209 111100
210 1100100
211 100
212 101000
213 1010
214 1010000
215 0
216 1010
217 1000

COUNTER
160 10010
161 0

PRESET
168 1
169 0

PC EPROM D46F-HYD-12
If any body can help, I will be thankful.

Regards,

Rajesh

[tobyaxis]

Have you tried Contacting Fanuc about this?

http://www.fanucamerica.com/fa_home/home.asp

Maybe Al_The_Man knows what the problem is. Send him a PM for Help.