Wondering how much pull stud runout i can get away with in my new fadal 4020 without damaging drawbar or anything else?. This is my first vmc so money is tight. I bought a bunch of used brand name holders and they are all fairly good, max i found was around 0.007" TIR. But i bought 3 chinese holders to try and one has about 0.019" TIR. Should i toss it or can it be used?
FWIW all 3 chinese holders were a dissapointment, lesson learned lol. One was a facemill holder, and the threaded hole that holds the face mill was drilled WAY oversize. Barely any thread there at all and bolt stripped out during assembly. Tapped it deeper, and with 1.5" of thread enguaged now with a longer bolt its ok. Second holder is an ER32 collet holder which looks great, but this is the one with the pull stud running out a mile. Third one is a 4" long ER16 holder and this one looks great and is machined fine, but the tool i bought was supposed to be a long thin holder to reach into tight spaces and the one they sent me had a huge 2" body with a tiny er16 nut at the end which makes no sense at all.