[Jim Dawson]

Here are two more pictures. It appears to me that the cross slide with the t-slots is deeper, so it requires the tool changer where the plate hangs off one side to get back into correct alignment with the spindle.

AKA you can't mount the version in this thread onto a cross slide with t-slots.

Ahh, those pictures help, makes sense now.

Get a measurement from the cross slide to the spindle C/L, then a measurement from the edge of the box to the hub center and that will tell the story. I assume you have one of the units in the pictures?

[crazybrit]

I have never seen a machine like yours so I'm shooting in the dark here.

Hi Jim. I'm sure one of the other people on this thread who has one of these lathes will comment in due course. Thanks.

[crazybrit]

https://www.intelitekdownloads.com/S...olight%203000/
"Use Version 4.1.0.8 for Windows 7"

Has anyone tried it with Win 10? My expectation is that it doesn't run (esp drivers) but I've not tried it and was curious if anyone has.

Answering my own question. The software functions perfectly on Windows 10. 32 and 64 bit OS versions.