585,875 active members*
4,057 visitors online*
Register for free
Login

Thread: Charmilles robofil 4020.0 lost reference

Results 1 to 4 of 4
  1. 07-21-2016, 07:50 PM #1
    xtrememachine
    xtrememachine is offline Registered
    Join Date
    Jul 2016
    Posts
    2

    Charmilles robofil 4020.0 lost reference

    If the power goes out, during the restart I get E070 execution inactive then E684 impossible operation. Which means I have lost my reference. My U axis is off by
    aprox. .750, So I do a guide setup and life is good till the next time. Some times the machine will shut down, startup , shut down and start up when either the generator
    or the pumps kick in with the same end result. I have replaced the K1 relay and went through all of the YV valves.
    Any suggestions would be appreciated.
    Reply With Quote Reply With Quote
  2. 07-29-2016, 03:24 PM #2
    mdynac
    mdynac is offline Registered
    Send a message via ICQ to mdynac
    Join Date
    Jan 2006
    Posts
    104

    Re: Charmilles robofil 4020.0 lost reference

    check your NC rack voltages. set 5 volts to 5.1 vdc measured at the backplane!!!!!!


    check and replace your batteries on the UA+SAL board.

    check your 24 vdc supply.

    thats a start
    Registered Linux User #348337
    EMC2 Rocks!!!!
    Reply With Quote Reply With Quote
  3. 07-29-2016, 04:14 PM #3
    xtrememachine
    xtrememachine is offline Registered
    Join Date
    Jul 2016
    Posts
    2

    Re: Charmilles robofil 4020.0 lost reference

    Thanks
    I checked the voltage on the SAL Restart board
    5 v check 4.93
    -12 checked 12.09
    +12 checked 11.82
    The battery checks 4.11 volts.
    Reply With Quote Reply With Quote
  4. 11-15-2019, 10:35 PM #4
    tspiszak
    tspiszak is offline Member
    Join Date
    Oct 2016
    Posts
    106

    Re: Charmilles robofil 4020.0 lost reference

    Hi. Do you still own this machine?

    Sent from my D5803 using Tapatalk
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. charmilles robofil 290
    By zekry10 in forum EDM Discussion General Topics
    Replies: 1
    Last Post: 02-24-2016, 02:25 AM
  2. DNC CHARMILLES ROBOFIL 310
    By tecnomaqq in forum EDM Discussion General Topics
    Replies: 0
    Last Post: 01-17-2014, 04:34 AM
  3. charmilles Robofil 190 or charmilles Robofil 290
    By Fontez in forum Post Processors for MC
    Replies: 0
    Last Post: 03-12-2013, 04:48 PM
  4. Charmilles Robofil 300 question
    By rtuls35 in forum EDM Discussion General Topics
    Replies: 3
    Last Post: 06-15-2011, 06:09 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules