hello everyone ,
i got a pcnc 1100 a couple of years a go and never had any real issues till now.
i was milling parts one day , changed to a different part , loaded a different .nc file and pressed 'cycle start' and got the following message :
ATC Button - USB command rejected
i talked to tormach guys (who are very responsive) and they suggested getting a new atc sensor , now i installed it and still get the same message.
also i tried reinstalling mach3 and i'm currently waiting for path pilot but i honestly doubt that it is a software error.
problem is machine doesn't even try to spin the atc, when i want to move the tray or do anything with atc i get message on mach3 ' reference ATC ,' nothing happens and than i get the message : ATC Button - USB command rejected
if any one of you had similar issues i would greatly appreciate any help i can get.
thank you ,
Dalibor