Hi,
Anyone knows if the XHC wired pendant works on PathPilot?
I'm going to buy a Tormach. But I don't think I like the control wheel they offer for PathPilot.
Hi,
Anyone knows if the XHC wired pendant works on PathPilot?
I'm going to buy a Tormach. But I don't think I like the control wheel they offer for PathPilot.
the xhc-04 wireless pendant will work ,but not out the box , although you will need to modify the config files and add a few files from a previous version of linuxcnc ,
i dont see why the wired version would not work , as it would only be a similar situation to the wireless version , i currently dont have a wired xhc to check
but with the correct information , i could make it work .
but again it would not be plug and play .
Thanks for the reply
I indeed found the topic for the wireless pendant. Shouldn't be a problem. I hope it works almost the same for the wired pendant.