[jmosley]

I've been using the Manual NC notes in Fusion360 - they are helpful when I come back to a job after a while and have forgotten details about the set-up.. Now i'd like my reminders to pop up in Pathpilot inbetween the tool changes..... I keep forgetting to change the spindle range back to at a certain point in my job after I use the slitting saw.. .I need a reminder.. Anyone know how I could make a message pop-up with a button that I'd have to hit to OK proceeding?

[kstrauss]

It is not exactly what you want but you could put your notes into the gcode as comments i followed by an M1 (optional stop).

[GLCarlson]

(MSG, your message here) prints to status screen. Combine with M01? 1100 Manual p 94

[jmosley]

Thanks! I found the MSG section in the manual and this is what I was looking for. Much appreciated!