[cmwincvp]

Has fanuc OI-TD control 2 axis. Samsung SL30 machine for bobcad v27 lathe
The processors that I have down loaded cant get canned cycle format wright
The u and w in second line of g71 does not match what is in z allowance and x allowance
Have tried editing processor but cant get it to change

Thanks

[SeanDa]

cmwincvp,

Do you know if your lathe is setup to run two line canned cycles like the output you are showing?

[cmwincvp]

Yes I can hand code it in the lathe and it will work. If I install file from cam in lathe I have to change the u and w output.

[SeanDa]

cmwincvp,

Ok, I think I know what your issue is. In V27, there was an issue with the U and W reversing the values they grab, so Z was always U and W was always X. Please attach your post processor and I will correct the output for you.

[cmwincvp]

U output needs to be U0.0100 and W 0.003.

[SeanDa]

cmwincvp,

I need the post processor you are using so I can correct that issue so the correct values output. Please attach it to this ticket in zip format and I will get it updated and will attach the updated post processor for you.

[cmwincvp]

Here is file

[cmwincvp]

Here is zip file

[SeanDa]

cmwincvp,

What I did was remove the callout for the rough_x_allowance and rough_z_allowance variables, and substituted it for the finish x and z allowance variables, which function the same as the rough variables, but instead of getting mirrored values, it outputs the correct allowance values. Give this a try and let me know if you have any issues with it.

[cmwincvp]

Hello Sean, Loaded file and this is what I got N45 G71 P50 Q65 U0.02 W0.003 F0.015. Note U is giving me double amount of what X is in cam.
Z amount is correct. U should read .0100 About a week ago I change line 249 to r and it changed U to correct amount but it changed all the X readings to. Had to change it back to d.

[SeanDa]

cmwincvp,

This post processor should work the way you need it to.

[cmwincvp]

Hello Sean, Loaded file and it works great!!!
Thanks a lot! Great to have someone like you to help!

[cmwincvp]

Hello Sean, I have another ordeal with default rapids. On Home Position X if I put in 5.00 in cam it will post 10.00 from processor.
N300 X10. in pic. It needs to match cam.

[SeanDa]

cmwincvp,

I cannot do anything to correct that. You will need to set 1/2 the amount for the home position you want in X.

[cmwincvp]

Ok. Thanks for the help.