[Shnitzl]

after years I am finally getting a Taig,
its a good choice that came by to get my feet wet.

I am hoping someone out there can maybe give some pointers on what software I should buy.
Mach 3 seems like the norm to run the mill, but what about design?

and general information to get me running.

if anyone wants to share some knowledge I would be very appreciative
in person always better then reading!

I am in Etobicoke

Mike.

[azurgrip]

I might be late, but my vote is for Fusion360.

I'm just in Mississauga.

[Shnitzl]

I might be late, but my vote is for Fusion360.

I'm just in Mississauga.

thanks! I did end up going with Fusion360.
still need to set up the Taig it arrived about a few weeks ago

what cnc machines do you own?