Trying to set up the x/y axis on my laser engraver. Nema 23 motors belt driven axis with a 2:1 step down ration. Motor gear has 24 teeth and the driven gear has 48 teeth. My table area is 500mm on X axis and 300mm on Y axis. Controller is AWC708C Lite. I can set range at 500 for X and 300 for Y but get either no where near that IE short by over half or it wants to try to go past that and just hammers the motor. I know my um/Pulse rate is off but I'm not sure how to figure them out. I have searched on here but nothing definitive has popped up oh actual steps to calculate the pulse rate.
Thanks in advance
Scott