585,575 active members*
3,937 visitors online*
Register for free
Login

Thread: change parameter, damn...

Results 1 to 4 of 4
  1. 08-17-2016, 12:26 AM #1
    alain aleman
    alain aleman is offline Registered
    Join Date
    Dec 2005
    Posts
    74

    change parameter, damn...

    Hi guys,
    Here my problem, i want to view the toolpath graphic mode in FANUC Oi Mate TD, i read the control manual and change the parameter 09100. Damn, Look what happen when i set up 1 in The fifth position. Now when push The system buttom works same like a graphic buttom and i can view The system interface again. Attached the step that i did and a video for best undestand, exists a way to back a system buttom works good?. Thanks for your attention and will waitung your suggest.
    Regards,
    Alain
    Reply With Quote Reply With Quote
  2. 08-18-2016, 11:01 PM #2
    alain aleman
    alain aleman is offline Registered
    Join Date
    Dec 2005
    Posts
    74

    Re: change parameter, damn...

    Any suggestions my friends???
    Reply With Quote Reply With Quote
  3. 08-19-2016, 03:15 AM #3
    STLMachinist
    STLMachinist is offline Registered
    Join Date
    Feb 2015
    Posts
    161

    Re: change parameter, damn...

    Load an old parameter backup. Otherwise you just altered your control forever.

    Possibly try pressing SYSTEM twice. Possibly, it will show the diagnostic screen and you can use the keys below the screen to get back to Parameter and change it back.
    Reply With Quote Reply With Quote
  4. 08-21-2016, 05:49 PM #4
    alain aleman
    alain aleman is offline Registered
    Join Date
    Dec 2005
    Posts
    74

    Re: change parameter, damn...

    How load the parameters?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. how do i change the tool change arm parameter ???
    By stevenlee in forum Fanuc
    Replies: 5
    Last Post: 05-19-2015, 10:42 PM
  2. Parameter change
    By Dean-R in forum Hitachi Seikis
    Replies: 2
    Last Post: 02-10-2014, 09:50 PM
  3. Change parameter
    By 1983CRAZYBB in forum Haas Mills
    Replies: 4
    Last Post: 03-10-2011, 05:06 PM
  4. Parameter change
    By adamant in forum Fanuc
    Replies: 1
    Last Post: 05-28-2008, 05:37 PM
  5. Tool Change Parameter
    By Jason812 in forum Fanuc
    Replies: 3
    Last Post: 11-21-2007, 02:29 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules