Originally Posted by
chjade84
First up, Cycle Stop. Can I change the cycle stop button to issue a command equivalent to M30 or "stop program and rewind to first line"? I just busted a nice tool because I stopped the program, did some adjustments and started the program only to have it continue on where it left off, but without turning on the spindle. If I just need to pause the program I can use Feed Hold.
Secondly, M6 tool changes are being ignored? I have the check box on "Stop spindle and wait for cycle start" but it doesn't. It just carries on with the program, ruining things, obviously. The code line is just "Txx M6".
Finally, can get UCCNC to start in windowed mode? No matter what I try it will always open maximized which is not how I want it to behave. Unlike most other programs that start as they were when closed, I can't get UCCNC to open at the same size and position I want it to. I have a large enough monitor to have multiple tools open at once and resizing and repositioning every time is a pain.