[Nike22]

Greetings to the members of the forum.
(I use google translate)
So, in fact I do not even know where to begin ...
The model is CHIRON FZ 20 drill.
Year 1981
FANUC 6M SINUMERIK 6M
The machine was purchased without any documentation. Absolutely nothing...
Machine long time standing without use.
The machine has a tape reader.
The machine has a parameter punched tape in the glove compartment box. (fortunately)
The problem is as follows:
- When starting the numerical display have ALARM and it is impossible to run anything.
- Controlled voltages, fuses, wiring - OK
My guess: because of long-standing system parameters are probably deleted. (Just my assumption)
The tape punched with the parameter I have.
- I noticed that the LED 3-2-1-0 on the main board is not bright. (In the photos because the flash looks like it, but do not light) I do not know if they ever need a light in a given situation)


I do not know where to go next move towards solving the problem. How to load the parameters? (If that is a problem, in fact)

In the photos you can see the appearance of the current situation.

I would ask for help, or documentation. Which way next?
I contacted "Chiron" company, but they said they could not help because the machine is very old, and they do not have more documentation available.

Thank you in advance and I apologize for my bad English

[rubens1963nova]

try contacting Fanuc to see if the NC control is working condition.