please help me
machine : HYPERTHERM POWERMAX PLASMA 45
Chinese FANGLING CONTROLLER
CHINESE HYDTHC torch height controller
HYPERTHERM Machine interface cable
HYPERTHERM Powermax45 MAchine torch
the Problem : plasma arc fires but the torch does not moves, ultimately extinguishing the Arc.
Questions:
1) My Chinese supplier says 4 wires are sufficient to operate this machine ( 2 for ARC START and 2 for ARC Voltages)
as per him, we must connect ARC START wires to HYPERTHERM pins 3 and 4
and ARC VOLTAGE wires to HYPERTHERM pins 5 & 6.
is it possible for the machine to work on these 4 wire connections.???
2) mistakenly, We connected ARC VOLTAGE wires to HYPERTHERM pins 12 & 14.
should this have damaged some component???
3) is it possible to run the machine without the torch height controller?
if Yes, How?
i have just set up my business .this machine is the backbone of my business.
i want to run this machine on any cost.
please help me