Good day all. We have an Omax 5555 and cannot reduce the cutting pressure to 20 KSI. At present we can only get the pressure down to 21.4 KSI at 644 RPM. We are running water only with a .005 sapphire jewel, a .005 dump valve jewel, and a .010 excessive overflow jewel. We have replaced all of the jewels, rebuilt the dual on/off valves and also the air actuators. We have run this set up for years and had no problems with our 3050 pump running at 20 KSI. Any ideas?
Results 1 to 2 of 2
-
08-29-2017, 01:16 PM #1
Registered
- Join Date
- Aug 2017
- Posts
- 4
Omax 5555 - cannot lower pressure to 20 KSI
-
10-03-2017, 04:00 PM #2
Registered
- Join Date
- Oct 2017
- Posts
- 1
Re: Omax 5555 - cannot lower pressure to 20 KSI
do you not have a low pressure setting in your setup screen?
Reply With QuoteSimilar Threads
-
Just bought an Omax 2652
By MBX5 in forum Waterjet General TopicsReplies: 14Last Post: 02-04-2022, 09:34 PM -
Leblond / Fanuc OM Lube Pressure No 2050 Oil Pressure Alarm
By alcarinc in forum Uncategorised MetalWorking MachinesReplies: 5Last Post: 01-13-2015, 03:02 AM -
Maxiem series Waterjets by Omax
By FAST LS1 in forum Waterjet General TopicsReplies: 3Last Post: 02-11-2014, 10:24 PM -
Anyone have a OMAX waterjet table?
By rpage in forum Waterjet General TopicsReplies: 19Last Post: 05-31-2010, 06:35 PM -
OMAX Files
By steeler1933 in forum Waterjet General TopicsReplies: 6Last Post: 05-04-2010, 03:47 PM
Tags for this Thread
Posting Permissions
