hi there!!
I am sorry if I am on the wrong place..
does any one knows how to make a parametric program where the line boring (amount of holes) increases or decreases as the panel size increases or decreases and always have the same distance on both ends?
I have something similar in WoodWop but I can't figure it out in xilog3 or maestro. This are some of the formulas I use in WoodWob
amount of holes - NH=MOD((L-9*2)/1.2598)+1
starting point of line bore - XC1=(L-DL)/2
distance from first to last hole - DL=(NH-1)*1.2598
thanks in advance!!