Originally Posted by
biederboat
Hi, we just bought a similar machines and are having the exact same problem. I measured the opening and there appears to be some tilt in the bed (about 10 mm left-right, not much front-back). However, it doesn't appear to be "binding", it's like it's seeing a software stop but nowhere near the limit switch (at least 4" below that). I'm having a hard time believing the factory didn't level and test before shipping and don't want to start repairing it from the get-go without being more cautious. I'm still learning the machine and all the other axis seem fine. Any suggestions?
Also, forgot to mention, you can actually run the u-axis into the stepper motors at the bottom (luckily I determined that through very careful jogging and not a hard crash). Overall, I'm just thinking they didn't set this up correctly.
Thanks,
BB