585,894 active members*
5,043 visitors online*
Register for free
Login

Thread: Miyano cnc

Results 1 to 4 of 4
  1. 02-05-2007, 08:45 PM #1
    gashbourne
    gashbourne is offline Registered
    Join Date
    Jan 2007
    Posts
    2

    Miyano cnc

    Hi.
    I recently moved our Miyano and now It wont run. Ipress start and no hyd. come on but I get an alarm 401 servo.
    I press reset but it just clicks in the panel and the alarm comes up again.

    any ideas please.

    Gasher
    Reply With Quote Reply With Quote
  2. 02-05-2007, 09:29 PM #2
    Al_The_Man's Avatar
    Al_The_Man
    Al_The_Man is offline Community Moderator
    Join Date
    Dec 2003
    Posts
    24221
    It helps if you give the the controller, If your hydraulics are not on then you don't have any power probabally to the servo's either, check the term 5&6 of the servo board if 110v missing, then you have a e-stop power problem more than likely.
    You need to get the schematics out and do some logical trouble shooting.
    Al.
    CNC, Mechatronics Integration and Custom Machine Design

    “Logic will get you from A to B. Imagination will take you everywhere.”
    Albert E.
    Reply With Quote Reply With Quote
  3. 02-05-2007, 09:36 PM #3
    gashbourne
    gashbourne is offline Registered
    Join Date
    Jan 2007
    Posts
    2
    Al the Man

    Thanks for your reply.
    The control is 6 T
    Hope this means something to you.

    Gasher
    Reply With Quote Reply With Quote
  4. 02-05-2007, 10:58 PM #4
    cncdiag
    cncdiag is offline Member
    Join Date
    Apr 2006
    Posts
    213
    Try changing the phasing of the power to the machine
    Swap any two wires.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. RS-232 Setup for Miyano w/Fanuc OT
    By JerryH in forum Fanuc
    Replies: 17
    Last Post: 01-20-2012, 02:17 PM
  2. is a miyano mtp-3 non existant ?
    By dt38k in forum CNC Tooling
    Replies: 0
    Last Post: 12-21-2006, 03:29 AM
  3. RS-232 Connection Miyano w Fanuc OT
    By JerryH in forum DNC Problems and Solutions
    Replies: 2
    Last Post: 12-28-2005, 03:13 AM
  4. Miyano Live-Tool
    By JerryH in forum G-Code Programing
    Replies: 2
    Last Post: 10-26-2005, 01:50 PM
  5. Miyano BND-34S Programming Help
    By JerryH in forum G-Code Programing
    Replies: 1
    Last Post: 10-10-2005, 02:11 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules