585,894 active members*
5,082 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Fadal > Fadal Idler problem. Rpm pulse problem

Thread: Fadal Idler problem. Rpm pulse problem

Results 1 to 2 of 2
  1. 10-02-2016, 07:16 PM #1
    complextool
    complextool is offline Registered
    Join Date
    Oct 2016
    Posts
    1

    Fadal Idler problem. Rpm pulse problem

    I have a Fadal 2216 that recently started to have an RPM surge up and down problem, mostly a lower RPM. The load meter goes up and down with the rpm of Spindle. if I keep spindle over ride at just below 100% it will stop surging. I just found a big air leak in the lower cylinder when that idler is not in use and extended. if I set RPM to use the higher RPM settings the lower cylinder does engage and air leak mostly goes away. Does anyone know if I change the lower air cylinder with the air leak coming out around shaft, if that will fix my problem.
    Thanks
    Jim
    Reply With Quote Reply With Quote
  2. 10-07-2016, 06:28 PM #2
    rodney247
    rodney247 is offline Registered
    Join Date
    Jan 2015
    Posts
    417

    Re: Fadal Idler problem. Rpm pulse problem

    Well at Fadal they had a saying Fix the obvious first so i would replace the cylinder.

    ITS: High Low Idler Cylinder, CYL-0006
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Pulse-coder, motor, or Velocity Control Problem
    By bergen13 in forum Cincinnati CNC
    Replies: 3
    Last Post: 11-13-2013, 05:21 AM
  2. Stepper Motor Pulse Input Problem
    By scratali in forum Stepper Motors / Drives
    Replies: 4
    Last Post: 05-20-2012, 09:07 PM
  3. uploading to fadal problem
    By bobo17 in forum Fadal
    Replies: 1
    Last Post: 03-14-2010, 01:10 AM
  4. fadal problem
    By Delvis in forum Uncategorised MetalWorking Machines
    Replies: 4
    Last Post: 02-09-2010, 05:09 PM
  5. pulse train to vfd, deceleration problem
    By chimpera in forum Mach Software (ArtSoft software)
    Replies: 3
    Last Post: 11-09-2009, 07:55 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules