[terminator]

I have a 4th axes from golden sun. The servo motor on it is a 1 kw 3 phase ac motor model number (HA 80 NT- E 30).
I have no servo amp but it looks like i need a (MDS-A-SVJ-10).

I need some one that can help me with this drive and to set it up with out the cnc control.
I cannot find the manuals that explain how you control this drive. I need the interface data so
that i can control either with step and direct signals or 0-10v analog input.

Help anyone as the factory do not even know what i am talking about but they made both the drive and motor !!!

Regards
Daniel

[Panasonicplc]

I have a 4th axes from golden sun. The servo motor on it is a 1 kw 3 phase ac motor model number (HA 80 NT- E 30).
I have no servo amp but it looks like i need a (MDS-A-SVJ-10).

I need some one that can help me with this drive and to set it up with out the cnc control.
I cannot find the manuals that explain how you control this drive. I need the interface data so
that i can control either with step and direct signals or 0-10v analog input.

Help anyone as the factory do not even know what i am talking about but they made both the drive and motor !!!

Regards
Daniel

do you still need the mitsubishi servo pack data?

[terminator]

do you still need the mitsubishi servo pack data?

I am sorry i have not been back here for a while now sir. Yes i do need the info on the drive and how to control it away from
the mitsubishi control. I would like to control it with step and direction signals like march 3 output if there is a way to do it.

Regards
Terminator

[navinbhas]

You would have to configure the drive to nc to run. I dont think would be possible to command the SVJ-10 drive through analog inout