[billetman123]

i lost my back-up battery (3.6v).
replaced it... now my machine reads in japanese.
i can't read japanese. any ideas how to get the parameters back in.
it's an akira seike mill and the people at People Tech don't seem to want to help.

[Al_The_Man]

The Meldas 64 manuals are on the MEAU site.
Al.

[billetman123]

thanks, Al.
i called mitsubishi and will be contacting the Mt. Vernon office tomorrow morning.
I will post what they can do for my problem.

tom

[marcunni24]

You should check the forum. I've seen the same problem posted, and they speak of modyfing the #1043 parameter (language). (And how to do it by memory).Good luck with that.

[marcunni24]

Since you are using the same controller as me... do you have any idea if the device in/out port (by default set at 0) can be put back to 0 if they were accidentaly changed? I can't manage to do so, and therefore can't establish a communication. Thanks

[wonk123]

How did you go getting this fixed? Where I work has the same drama, and we got a tech out to fix it. He couldn't access the option parameters (first 16 parameters). He thinks there may be a password on it for these. Anybody have any ideas

[Russell840]

How did you go getting this fixed? Where I work has the same drama, and we got a tech out to fix it. He couldn't access the option parameters (first 16 parameters). He thinks there may be a password on it for these. Anybody have any ideas

try to read BNP-B2180 carefully, and BNP-B2192
best regards
Russell