554,973 active members*
2,145 visitors online*
Register for free
Login

Thread: Calibration

Results 1 to 2 of 2
  1. #1
    Registered
    Join Date
    May 2014
    Posts
    1

    Unhappy Calibration

    Please help me rdworks calibration x/y
    machine=1800x1300mm

  2. #2
    Registered
    Join Date
    Oct 2016
    Posts
    14

    Re: Calibration

    If these are 2 runs of the same pattern, then a repeat-ability problem exists. I would check for loose belts, that is to say loose enough for the belt to slip over the pulley teeth. It is also possible for the belt to be too tight, but it is unlikely. Also, ensure that the head travels smoothly, if it binds at all during travel you will loose steps. If you have just received the machine, go over it looking for loose bolts, nuts, & screws. When we received our machine we found many that had come loose during shipping.

    I am sure that some other can chime in with other suggestions.

Similar Threads

  1. Calibration Help
    By Jamesdee in forum Stepper Motors / Drives
    Replies: 0
    Last Post: 09-06-2015, 04:42 PM
  2. X Y Calibration?
    By Robofarmer in forum General Laser Engraving / Cutting Machine Discussion
    Replies: 4
    Last Post: 06-30-2015, 02:45 PM
  3. Calibration
    By slamman in forum DIY CNC Router Table Machines
    Replies: 6
    Last Post: 03-13-2012, 08:08 PM
  4. Need calibration help
    By JasonCcnc in forum DIY CNC Router Table Machines
    Replies: 2
    Last Post: 07-25-2011, 03:11 AM
  5. Calibration
    By metalfixer in forum General Waterjet
    Replies: 5
    Last Post: 12-22-2008, 11:27 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •