Re: How to set a large tool?
I tried S_7,L for a large tool on ATC POT NO. / TOOL NO. TABLE screen but syntax error returned
hy, what i will say is from an osp300; hope this procedure is similar with yours
If with "ATC POT NO. / TOOL NO. TABLE" you reffer to same location, than this location is related to a register, where you can define a lot of data for each tool, including " L ( heavy ) " atribute. This register should be accesed from same page where "ATC POT NO. / TOOL NO. TABLE" is, but from a different tab.
Setting " L ( heavy ) " requires neighbour pots to be empty, so to auto-assign them the " D ( dummy ) " atribute.
If with "ATC POT NO. / TOOL NO. TABLE" you reffer to same location > this location should not allow you to declare more tools than magazine capacity
This location links to a tool register, that may contain much more tools than the magazine capacity ; i think you must find & edit this register, and after just link the new field to "ATC POT NO. / TOOL NO. TABLE" location / kindly !
Ladyhawke - My Delirium, https://www.youtube.com/watch?v=X_bFO1SNRZg