What are other people using when they convert the Taig mill to a variable speed DC motor? I don't want stepped pulleys, just a single ratio, probably 1:1.5 step-up for a somewhat higher spindle speed. Is a 1/4" flat belt suitable for this? I don't have the capability to make cogged pulleys. The motor shaft is 17mm (about 0.669" D X 1" long). Any ideas or advice appreciated!
Jack
Results 1 to 3 of 3
-
12-05-2016, 01:11 AM #1
Registered
- Join Date
- Jun 2009
- Posts
- 118
Advice Needed: DC Motor Pulleys and Belt
-
12-09-2016, 12:20 AM #2
Registered
- Join Date
- Jun 2009
- Posts
- 118
Re: Advice Needed: DC Motor Pulleys and Belt
Anyone?? Is there a better forum for my questions on this topic?
-
03-30-2018, 04:25 AM #3
Member
- Join Date
- May 2009
- Posts
- 1332
Re: Advice Needed: DC Motor Pulleys and Belt
I use a Sherline 90VDC with a KBIC controller which varies the speed from about 300 RPM to 10K. I got both as a set including a Taig headstoc with ER16. Check on Sherline site for the motor and KBIC
Nicolas
Reply With QuoteSimilar Threads
-
belt drive pulleys ...
By CNCpatriot in forum Linear and Rotary MotionReplies: 0Last Post: 08-01-2010, 04:10 PM -
Help about Pulleys and belt for 4th axis
By Rene Nuñez Paz in forum DIY CNC Router Table MachinesReplies: 2Last Post: 01-19-2010, 01:17 AM -
Some advice needed on X-Axis belt issues.
By kumaichi in forum Charter Oak Automation Support ForumReplies: 14Last Post: 02-21-2007, 03:47 PM -
Belt Drive - advice needed
By Pat2000 in forum Linear and Rotary MotionReplies: 11Last Post: 11-01-2005, 03:11 PM
Tags for this Thread
Posting Permissions
